3
The construction above is the easiest to fit and should be used if possible. Another lay out is
shown below but this requires much more careful measuring and recovery from error in
measurement and cutting “WORKTOP 3” to size is limited.
WORKTOP 1
WORKTOP 2
WORKTOP 3
POSTFORMED EDGE
PO
STFO
R
MED
ED
G
E
P
O
S
T
FO
R
M
E
D
E
D
G
E
LINE C
INSET 35mm
1. CUT FEMALE MITRES ON WORKTOPS 1 & 2
2. INSTALL WOKKTOPS 1 & 2
3. MEASURE DISTANCE BETWEEN MITRE CUTS - "B ABOVE"
4. CUT MALE MITRE ON RIGHT HAND END OF W'TOP 3
5. DRAW "LINE C"
LINE C IS LENGTH B MINUS 193mm FROM MALE CUT
6. SET JIG ON LINE C AS SHOWN BELOW AND CLAMP
7. CUT MALE MITRE ON LEFT HAND END OF WORKTOP 3
193
B
USING THE JIG and THE HOLES EXPLAINED
CUTTING BOLT SLOT
PEG HOLES FOR
PEG HOLES FOR
PEG HOLES FOR
PEG HOLES FOR
MALE CUTS
FEMALE CUTS
600mm 616mm
FEMALE MITRE SET UP
WORKTOP FACE
Postformed Edge
RIGHT HAND FEMALE CUT
Postformed Edge
LEFT HAND FEMALE CUT
WORKTOP BACK
PEG
PEG
PEG
PEG
START CUT HERE
START CUT HERE
MALE MITRE SET UP
