C.I.B. UNIGAS - M039196CC
28
18 Turn the burner off then start it up again.
19 Once the pre-purge time comes to end and the burner is on, drive the burner to the high flame stage by the
TAB
thermostat: check
the combustion values;
20 drive the burner to low flame, if necessary adjust the low flame size (output) by inserting a screwdriver on the slot
F
to move the
BF
cam.
21 The low flame position must never match the ignition position that is why cam
BF
must be set 20°- 30° more than the ignition posi-
tion.
22 Turn the burner off; then start it up again. If the adjustment is not correct, repeat the previous steps.
Calibration of air pressure switch
(only for PN520 - PN525)
To calibrate the air pressure switch, proceed as follows:
z
Remove the transparent plastic cap.
z
Once air and heavy oil setting have been accomplished, startup the burner.
z
During the pre-purge phase o the operation, turn slowly the adjusting ring nut
VR
in the
clockwise direction until the burner lockout, then read the value on the pressure switch
scale and set it to a value reduced by 15%.
z
Repeat the ignition cycle of the burner and check it runs properly.
z
Refit the transparent plastic cover on the pressure switch.
Fully-modulating burners
To adjust the fully-modulating burners, use the
CMF
switch on the burner control panel (see next picture), instead of the
TAB
thermo-
stat as described on the previous paragraphs about the progressive burners. Go on adjusting the burner as described before, paying
attention to use the CMF switch intead of
TAB
.
The
CMF
position sets the oprating stages: to drive the burner to the high-flame stage, set CMF=1; to drive it to the low-flame stage, set
CMF=2.
To move the adjusting cam set CMF=1 or 2 and then CMF=0.
BF
F
VR
CMF
CMF = 0 stop at the current position
CMF = 1 high flame operation
CMF = 2 low flame operation
CMF = 3 automatic operation
Summary of Contents for PN510
