Unigas HR92A, Manual Of Installation - Use - Maintenance

Page: 34 / 140

PART III: OPERATION
34
The display will show these data:
The display will show these data:
Setting menu
The setting menu is divided into different blocks:
Key F
Used to adjust the “fuel” actuator position ( F uel): :
While pressing the F key, the “fuel” actuator position can be changed by means of the + and - keys.
Key A
Used to adjust the “air” actuator position ( A ir):
While pressing the A key, the “air” actuator position can be changed by means of the + and - keys.
Key F + A
While pressing the two keys contemporarly, the code message will appear: by entering the proper
password it is possible to access the Service mode.
Info and Enter keys
Used for Info and Service menues
Used as Enter key in the setting modes
Used as Reset key in the burner operation mode
Used to enter a lower level menu
-Key -
Used to decrease a a value
Used to enter Info and Serivce during the curve adjustments
+Key +
Used to increase a a value
Used to enter Info and Serivce during the curve adjustments
Keys (+ & - )= ESC
By pr and - at the same time, the ESCAPE function is perfomed:
to enter a lower level menu
Bloc. Descrizione Description Password
100 Informazioni generali General OEM / Service / Info
Lock+unlock codes
Flame
Open valves
Fan motor energised
Oil pre-heater energised
Ignition transformers energised
Plant heat request
Parametere setting mode
Info mode
Service mode
Closing actuator
Opening actuator
Unit measure