UniFlow MiCard PLUS-2 V2, Installation Manual

Page: 13 / 22

MiCard PLUS-2 V2
1
1 Introduction
The MiCard PLUS-2 V2 is a USB card reader that combines proximity and contactless
technologies into one single reader. MiCard PLUS-2 V2 possesses the capabilities of
reading both 125 kHz proximity cards and 13.56 MHz contactless cards. This reader
eliminates the need for manual entry and provides error-free identification and
security throughout the workplace. The MiCard PLUS-2 V2 allows users to use their
building access card / time tracking card or any 125 kHz or 13.56 MHz tags/labels for
identification in conjunction with Canon MEAP enabled devices (V3.0.8 onwards),
Canon SFP MEAP devices (V1.0.2 onwards), a microMIND V2 (since firmware V2.0.5)
with an attached reader and the uniFLOW Embedded Applet for Hewlett-Packard /
Samsung / Océ Large Format Printers. The plug and play reader comes with flash
memory, allowing the user to quickly configure the output to meet the needs. With its
dual-frequency multi-technology, the MiCard PLUS-2 V2 is highly configurable and can
hold four different ID card configurations (2 are pre-set and 2 are user definable).
The reader can be configured to add characters before or after the card’s data.
2 Connection
Connecting the Card Reader
Connect the card reader to the USB 2.0 port at the rear side of the device.
Using the USB port at the front side / user panel might cause the error message:
"An unsupported USB device is connected."
3 Beep Status
The MiCard PLUS-2 V2 reader is equipped with a beeper which emits different beep
tones for different statuses. The table below shows the status information given by the
beeper.
Status of the Beeper Beep Signal
The MiCard PLUS-2 V2 is booting up. 1 x short
A card has been detected. 1 x short