background image

15 

Operating Instructions  (continued) 

 

.

CAUTION

 

W

If burner flame goes out during operation, 

immediately turn the control knob to the 

 

(OFF) 

position and Gas cylinder valve “OFF” and open 

lid to let the gas clear for 5 minutes before re-

lighting. 

Turning Off

1 .  Turn gas cylinder valve to “CLOSED .”
2 .  Turn all control knobs clockwise to the 

 (OFF) position . 

Note: A “poof” sound is normal as the last of the LP gas is burned .

3 .  Disconnect gas cylinder per “Disconnecting Gas Cylinder” section .

.

WARNING

 

W

When cooking, fire extinguishing materials 

should be readily accessible.  In the event of 

an oil/grease fire, use type BC dry chemical 

fire extinguisher or smother with dirt, sand 

or baking soda. Do NOT attempt to extinguish 

with water.

Controlling Flare-ups

1.  If a grease fire develops, turn control knobs to the 

 

(OFF) position and Gas cylinder valve “CLOSED.” Do NOT use water 

on a grease fire. This can cause the grease to splatter and could result in serious burns, bodily harm or other damage. 

2.  Do NOT leave grill unattended while preheating or burning off food residue on   (HIGH). If grill has not been cleaned, a 

grease fire can occur.

Flare-ups are a part of cooking meats on a grill and add to the unique flavor of grilling .

Excessive flare-ups can over-cook your food and be dangerous.

 

Important:

 

Excessive flare-ups result from the build-up of grease in the bottom of your grill . 

If a grease fire occurs

, close the lid 

AND

 turn the control knob(s) to 

 (OFF) until the grease burns out . Be careful when 

opening the lid as sudden flare-ups may occur .
If excessive flare-ups occur, 

do NOT

 pour water onto the flames .

Minimize Flare-ups:

1 .  Trim excess fat from meats prior to cooking .
2 .  Cook high fat content meats on   (LOW) setting or indirectly .
3 .  Ensure that your grill is on a hard, level, non-combustible surface and the grease is allowed to drain into grease receptacle .

Operating Side Burner

Note:   Side burner can be used while main burners are operating . 

Never use side burner as a grill .

 

W

CAUTION: Maximum weight for side burner and side shelf is 15 kgs.

 

W

CAUTION: Using pots larger than 6 quarts or 240 mm diameter in capacity could exceed weight 

limit of the side burner shelf, resulting in failure of grill cart components.

 

W

CAUTION: Do NOT lean on the side burner shelf.

 

W

CAUTION: Attempting to light the burner with the lid closed may cause an explosion.

Figure 7

Lighting 
Rod

Match

Lighting

1 .  Open lid .
2 .  Check for obstructions of airflow to the burners . Spiders, insects and webs can clog the burner/venturi tube  A clogged 

burner tube can lead to a fire .

3 .  Control knob must be in the 

 (OFF) position (Figure 3) .

4 .  Connect gas cylinder per “Installing Gas cylinder” section .
5 .  To turn regulator ON, turn the regulator valve handle clockwise into the the “ON” position .  

(Figure D) 

6 .  Push and turn control knob to   (HIGH) . The burner should light . If not, repeat up to three times .
7 .  If ignition does not occur in 5 seconds, turn burner control knob 

 (OFF), wait 5 minutes and repeat lighting procedure .  

8 .  If igniter does not light burner, use a lit match secured with the lighting rod (included with grill) to light burners . Position 

the lit match near side of the burner (Figure 7) .

Important:

 Always use the lighting rod (included) when lighting burner with a match .

9 .  After lighting, observe the burner flame . Make sure all burner ports are lit and flame height matches illustration (Figure 

6) .

 

W

CAUTION: If burner flame goes out during operation, immediately turn the control knob to the 

 

(OFF) position and Gas cylinder valve “OFF” and open lid to let the gas clear for 5 minutes 

before re-lighting. 

Turning Off

1 .  Turn gas cylinder valve to “OFF .”
2 .  Turn control knob clockwise to the 

 (OFF) position . 

Note: A “poof” sound is normal as the last of the LP gas is burned .

3 .  Disconnect gas cylinder per “Disconnecting Gas Cylinder” section .

Cooking

1 .  Open lid and ignite the side burner per “Lighting” instructions . 
2 .  Adjust control knob to desired flame height . 
3 .  Place pan on center of grid .
4 .  Cook and adjust temperature as needed .
5 .  Turn grill off per “Turning Off” instructions .

 

.

CAUTION

 

W

Putting out grease fires by only closing the lid is 

not possible. 

Summary of Contents for GBC1765WL-U




















Reviews: