Uniden XS215, Owner'S Manual

Page: 11 / 36

11
GETTING STARTED
The digital security code is an identification code used to connect the handset and the base unit. Normally, setting the
code is not necessary. The first time you charge your handset, the security code is automatically set.
In the rare situation that you suspect another cordless telephone is using the same security code, you can change the code.
1) Remove the handset from the base unit. Press and hold
on the base.
2) While holding , place the handset on the base unit, and leave the handset on the base for more than 3
seconds. A new random security code is set.
CHANGING THE DIGITAL SECURITY CODE
To attach the beltclip
Insert the beltclip into the holes on each side of the handset. Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.
INSTALLING THE BELTCLIP
Your phone may be used with an optional headset, the Uniden HS910.
To use this feature, insert the headset plug into the headset jack.
Your phone is ready for hands-free conversations.
(Headset may be purchased by calling the Uniden Service Division or visiting the web site, or
through your local retailer.).
HEADSET INSTALLATION
To protect you against
misbilled calls which might
result from your phone
being activated by other
equipment, the cordless
phone has
Auto Secure
feature electronically locks
your phone when the
handset is in the base. Also,
the
Random Code
digital security which
automatically selects one of
over 262,000 digital
security codes for the
handset and base.
XS215.Qx 10/21/03 5:45 PM Page 11