35mm
100mm
3mm
5. Once the handset battery pack
is fully charged, connect the
telephone cord to the
TEL
LINE
jack and a telephone
outlet.
D. Mount the base unit on a wall
Standard wall plate mounting
This phone can be mounted on any standard wall plate.
1. Locate the base unit on the wall mount adaptor
as shown and slide the wall mount adaptor into
the notches on the base bottom with the tab
pressed.
2. Plug the AC adaptor into the
DC IN 9V
jack.
3. Route the AC adaptor cord through the molded
wiring channel as shown.
4. Plug the AC adaptor into a standard
240V AC
wall outlet.
5. Plug the telephone cord into the
TEL LINE
jack. Route the cord through the molded wiring
channel as shown.
6. Plug the telephone cord into the telephone
outlet (socket image shown is indicative only).
7. Align the mounting slots on the base with the
mounting posts on the wall. Then push in and
down until the phone is firmly seated.
Direct wall mounting
If you don't have a standard wall plate, you can mount your phone
directly to the wall. Before doing this, consider the following:
•
Avoid electrical cables, pipes, or other items behind the mounting
location that could cause a hazard when inserting screws into the wall.
•
Try to mount your phone within 1.5m of a working phone jack to
avoid excessive cord lengths.
•
Make sure the wall material is capable of supporting the weight of
the base and handset.
•
Use #10 screws (minimum length of 35mm) with anchoring
devices suitable for the wall material where the base unit will be
placed.
1. Insert two mounting screws into the wall, (with their appropriate
anchoring device), 100mm apart. Allow about 3mm between
the wall and screw heads for mounting the phone.
2. Refer to steps 1 through 7 above to mount the telephone.
[4]
1
2
3
4
5
6
7
7
Australia
Tel Line Adaptor (Not supplied)