31
Installing a line Filter or Dsl Filter
A telephone line filter or DSL filter prevents
services that use the phone line from causing
interference on your phone. To get a line filter,
contact your service provider or look in an
electronics store.
Plug the filter into the telephone wall jack and
plug the base into the filter. Make a test call to
make sure the noise is gone.
liquid Damage
If the liquid is only on the exterior housing of the base or handset, wipe it off and use as
normal. If you can hear liquid inside the housing:
1. Disconnect all cables and cords and remove all compartment covers.
2. If liquid is leaking from any vent or hole, turn the phone so that vent faces down. If
not, place the largest vent face down.
3. Let dry for at least 3 days. Check for liquid inside the phone before replacing
compartment covers and reconnecting cords.
CAUTION:
If the base is covered in liquid, disconnect the adapter and phone cord
from the wall before touching it.
resetting a handset
If you have trouble with a handset or if you want to replace one, reset it:
1. Press and hold
END/CLEAR
and
#/ DND
at the same time until
System Reset
displays
(about 5 seconds).
2. If you still have the base the handset is registered to, select
Deregister HS
, then
select the handset you want to reset. If you don’t have that base anymore, select
Base Unavailable
.
3. To confirm, select
Yes
. The handset displays
Handset not registered
.
registering a handset
If you see a “not registered” message on a handset, you must register it to a base
before using it.
1. Place the handset in the base; the display should say
Handset Registering
.
2. Wait until the handset display says
Registration Completed
(about 30 seconds), then
pick up the handset.
#
If you don’t hear a dial tone or the display says Registration Failed, charge the
battery completely, then try again.
