Uniden WNP1000, Owner'S Manual

Page: 12 / 29

23
A sample WEP configuration using a passphrase is shown in
the following figure.
24
Manual Key Entry
To manually enter the WEP keys, perform the following steps:
1. Select either 64-bit or 128-bit WEP encryption from the
pull-down menu.
2. Click on Manual (Enter in the table below).
3. When WEP 64-bit is selected, type five alphanumeric
characters in the range of “a-z”, “A-Z” and “0-9” (e.g.
MyKey) in the WEP Key 1 entry field. Alternatively, you
may enter 10 digit hexadecimal values in the range of
“A-F” and “0-9” (as shown in the example below).
You can also enter WEP keys in the Key 2, Key 3 and
Key 4 if you wish. Select the active WEP key set (1, 2,
3, or 4) for 64-bit encryption. WEP 128-bit encryption
uses only one key. Verify that you are using the same
active key for all clients on your wireless network.
4. Click Apply . Remember that changes do not take
effect until after you restart your WNP1000 Wireless
AP by clicking the Reboot button.