Fitting Instructions
UH9000S / UH9060S / UH9080S
Page 11 of 12
4.
Connect the power lead patch harness to the UHF CB
transceiver.
5.
Fit the antenna adapter (supplied) to the antenna cable
and connect to the UHF CB transceiver.
6.
Slide the UHF CB transceiver into the cradle.
Neatly position the excess antenna cable and power lead
patch harness below the centre of the instrument panel.
7.
Neatly cable tie the excess antenna cable and power cable
to avoid rattling and fouling. Use self-adhesive cable tie
mount blocks where necessary
8.
Refit the cup holder using existing fasteners.
Speaker Microphone Hanger
1.
Using a suitable primer clean the instrument panel at the
hanger mounting location.
2.
Assemble the (2) halves of the speaker microphone
hanger using the (2) nuts and screws supplied.
3.
Secure the microphone hanger to the left of climate
controls in the position shown using double sided tape.
