Uniden UBC180XLT, Operating Manual

Page: 21 / 36

Scanning
Bank Scanning
1. If SCAN is not indicated on the display, press .
The UBC180XLT should begin scanning.
The indicators for the selected Banks ( 1 through 10 ) appear
on the display. The indicator of the Bank currently being
monitored flashes. While the
UBC180XLT is scanning, the
word SCAN moves across the display.
Scanning stops on any active channel that is not “Locked
Out”, and displays the Channel Number and frequency or
Alpha Name. Scanning resumes automatically after the
transmission stops.
2.
You can deselect any bank(s) from being scanned by
entering the number of the bank. The deselected bank
indicator(s) disappear from the display, and those
channels will not be scanned. This procedure helps to
speed up the scanning cycle.
Note: One Bank must always be active. You cannot
deactivate all 10 banks at the same time. If you try to
deactivate all 10 Banks, Bank 1 will automatically
be active.
3.
To restore any bank for scanning, just enter its number
again. The bank indicator will reappear on the display.
4. To stop scanning any time, press . ( HOLD appears
on the display.) The scanner remains on the displayed
channel, and only the bank indicator for that channel
appears. Press
, to resume scanning.
5.
When you are stopped at a channel, you can press
to step down a channel, or
to step up a channel.
Press and hold either key to rapidly step through the
channels.
Note: You do not skip a locked out (“ L/O ”) channel when
you use or .
18
22
Y:...UBC180XLT(7_15).vp
Tue Jul 15 16:17:20 2003
Color profile: Disabled
Composite Default screen