Installing the Rear Camera (for iGoCam 75R)
Always check the label on the rear camera cable before connecting the
camera to the rear camera and front camera. This is to ensure the cable is
connected to the corresponding connector port. Otherwise, the rear camera
video feed will not display on the front camera screen.
1. Peel off the sticker protective film from the 3M sticker on the rear camera.
2. Mount the rear camera and apply force on the mount onto the centre rear
of the windshield.
3. Check the label on the rear camera cable before connecting one end to the
rear camera and the other end to the front camera.
4. Arrange and hide the cables to avoid obstruction for the driver’s rear view.
5. Adjust the viewing angle of the camera. We recommend the camera should
point slightly downwards ~10° below eye level.
When the rear camera is connected to the front camera and it is currently
powered on, the rear camera will be displayed in the right side of the LCD
screen. The recording resolution for the rear camera is 1080P.
NOTE
Please ensure the rear camera connection cable is connected/
disconnected when the device power is off or it will damage
the product.
GPS Reception information
Surroundings with tall buildings, tunnels or poor weather conditions may
result in poor GPS reception or even lose GPS signal. Over-tinting or a rain
sensor on the windshield can affect GPS reception.
If the signal is unstable even when you are driving, please try changing the
installation spot of your dash camera. For the first time use, it takes about
15~20 minutes to get GPS signal, and after that, it normally takes about 3
minutes.
NOTE
Sticker mount is difficult to remove after it is installed and will
not stick well on a curved/textured or wet surface.
8
Vehicle Recorder
UNIDEN iGO CAM 75/75R
