background image

Operating 

Frequency

UHF 462.5500 - 467.7125 MHz

Power Source

3

 

AA

 

NiMH Batteries

 

per radio

FREQUENCY CHART

CH

Freq.[MHz] -  

Cross Ref. 

CH

Freq.[MHz] -  

Cross Ref.

1

462.5625 - FRS & 

GMRS 1

12

467.6625 - FRS 12

2

462.5875 - FRS & 

GMRS 2

13

467.6875 - FRS 13

3

462.6125 - FRS & 

GMRS 3

14

467.7125 - FRS 14

4

462.6375 - FRS & 

GMRS 4

15

462.5500 - GMRS 

11

5

462.6625 - FRS & 

GMRS 5

16

462.5750 - GMRS 

8

6

462.6875- FRS & 

GMRS 6

17

462.6000 - GMRS 

12

7

462.7125 - FRS & 

GMRS 7

18

462.6250 - GMRS 

9

8

467.5625 - FRS 8

19

462.6500 - GMRS 

13

9

467.5875 - FRS 9

20

462.6750 - GMRS 

10

10

467.6125 - FRS 10

21

462.7000 - GMRS 

14

11

467.6375 - FRS 11

22

462.7250 - GMRS 

15

Note:This product is considered FRS only with 22 FRS 

channels in the US market.It is considered a 

GMRS product in the Canadian market. 

RBRC INFORMATION

As part of our commitment to protect the  

environment and conserve natural  

resources, Uniden voluntarily participates  

in an RBRC® industry program to collect  

and recycle used Ni-MH batteries within  

the US. 
Please call 1-800-8-BATTERY for information on Ni-MH 

battery recycling in your area. (RBRC® is a registered 

trademark of the Rechargeable Battery Recycling 

Corporation.) 

MAINTENANCE

To be safe and sure:

•  Never open your radio’s case.
•  Never change or replace anything in your radio 

except the batteries.

Care and Safety

Body-Worn Operation

This device was evaluated for body-worn operations 

with the supplied belt-clip accessory. (All necessary 

accessories are included in the package; any 

additional or optional accessories are not required for 

compliance with the guidelines.)  Third party 

accessories (unless approved by the manufacturer) 

should be avoided as these might not comply with 

FCC RF exposure guidelines. 
For body-worn operation, this device has been tested 

and meets the Industry Canada RF exposure 

guidelines when used with Uniden accessories 

supplied or designated for this product. Use of other 

accessories may not ensure compliance with Industry 

Canada RF exposure guidelines.
Fonctionnement de l’appareil, lorsque porté sur le 

corps. Cet appareil a été testé et s’est avéré conforme 

aux normes d’Industrie Canada et approuvé pour le 

port sur le corps à l’aide des accessoires Uniden 

inclus et conçus pour cet appareil. L’utilisation 

d'accessoires ne respectant pas les exigences 

d'exposition RF d’Industrie Canada doit être évitée. 

FCC PART 15/IC COMPLIANCE

This device complies with part 15 of the FCC Rules. 

Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference, 

and (2) this device must accept any interference 

received, including interference that may cause 

undesired operation.
Changes or modifications not expressly approved by 

the party responsible for compliance could void your 

authority to operate the equipment.
Avis de conformité à la FCC : Ce dispositif a été testé 

et s’avère conforme à l’article 15 des règlements de la 

Commission fédérale des communications (FCC). Ce 

dispositif est soumis aux conditions suivantes: 1) Ce 

dispositif ne doit pas causer d’interférences nuisibles 

et; 2) Il doit pouvoir supporter les parasites qu’il reçoit, 

incluant les parasites pouvant nuire à son 

fonctionnement.
Tout changement ou modification non approuvé 

expressément par la partie responsable pourrait 

annuler le droit à l’utilisateur de faire fonctionner cet 

équipement.

IC COMPLIANCE 

This device contains license-exempt transmitter(s)/

receiver(s) that comply with Innovation, Science and 

Economic Development Canada's license-exempt 

RSS(s). Operation is subject to the following two 

conditions:

1.  This device may not cause interference. 

2.  this device must accept any interference, 

including interference that may cause undesired 

operation of the device.

Changes or modifications not expressly approved by 

the party responsible for compliance could void your 

authority to operate the equipment.
Cet appareil contient un ou des émetteurs/récepteurs 

exemptés de licence qui sont conformes aux normes 

RSS d'Innovation, Sciences et Développement économique 

Canada exemptées de licence. L'utilisation est soumise aux 

deux conditions  

suivantes :

1.  Cet appareil ne doit pas causer d'interférences.

2.  Cet appareil doit accepter toute interférence, y compris 

les interférences susceptibles de provoquer un 

fonctionnement non désiré de l'appareil.

Tout changement ou modification non approuvé expressément 

par la partie responsable pourrait annuler le droit à l’utilisateur 

de faire fonctionner cet équipement.

ONE YEAR LIMITED WARRANTY

IMPORTANT! SAVE YOUR RECEIPT!

 Evidence of original 

purchase is required for warranty service.

WARRANTOR:  UNIDEN AMERICA  CORPORATION 

("Uniden")
ELEMENTS OF WARRANTY: Uniden warrants, for one year, 

to the original retail owner, this Uniden Product to be free from 

defects in materials and craftsmanship with only the limitations 

or exclusions set out below.
WARRANTY DURATION:  This warranty to the original user 

shall terminate and be of no further effect 12 months after the 

date of original retail sale. The warranty is invalid if the 

Product is:  (A) damaged or not maintained as reasonable or 

necessary, (B) modified, altered, or used as part of any 

conversion kits, sub-assemblies, or any configurations not 

sold by Uniden, (C) improperly installed, (D) serviced or 

repaired by someone other than an authorized Uniden service 

center for a defect or malfunction covered by this warranty, (E) 

used in any conjunction with equipment or parts or as part of 

any system not manufactured by Uniden, or (F) installed or 

programmed by anyone other than as detailed by the owner’s 

manual for this product.
STATEMENT OF REMEDY:  In the event that the product 

does not conform to this warranty at any time while this 

warranty is in effect, warrantor will either, at its option, repair 

or replace the defective unit and return it to you without 

charge for parts, service, or any other cost (except shipping 

and handling) incurred by warrantor or its representatives in 

connection with the performance of this warranty. Warrantor, 

at its option, may replace the unit with a new or refurbished 

unit.
THE LIMITED WARRANTY SET FORTH ABOVE IS THE 

SOLE AND ENTIRE WARRANTY PERTAINING TO THE 

PRODUCT AND IS IN LIEU OF AND EXCLUDES ALL 

OTHER WARRANTIES OF ANY NATURE WHATSOEVER, 

WHETHER EXPRESS, IMPLIED OR ARISING BY 

OPERATION OF LAW, INCLUDING, BUT NOT LIMITED TO 

ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR 

FITNESS FOR A  PARTICULAR PURPOSE.THIS 

WARRANTY DOES NOT COVER OR PROVIDE FOR THE  

REIMBURSEMENT OVERPAYMENT OF INCIDENTAL OR 

CONSEQUENTIAL DAMAGES. Some states do not allow this 

exclusion or limitation of incidental or consequential damages 

so the above limitation or exclusion may not apply to you.

To clean the radio, use a soft cloth dampened with 

water. Do not use cleaners or solvents because they 

can harm the body of the unit and leak inside, causing 

permanent damage. Use a dry, lint-free cloth to clean 

the battery contacts. Do not submerge the unit in 

water. If the unit gets wet, turn it off and remove the 

batteries immediately.
Dry the battery compartment with a soft cloth to 

minimize potential water damage. Leave the battery 

compartment cover off overnight to ensure complete 

drying. Do not use the radio until the unit is completely 

dry.
Your radio might cause TV or radio interference even 

when it is operating properly. To determine whether 

your radio is causing the interference, turn it off. If the 

interference goes away, your radio is causing it. Try to 

eliminate the interference by moving your radio away 

from the receiver. If you cannot eliminate the 

interference, the FCC requires that you stop using the 

radio.

Hazardous Environments

Do not operate the radio in hazardous environments. 

Explosion or fire may result. Do not operate the radio 

near unshielded electrical blasting caps.
Under certain conditions, radios can interfere with 

blasting operations and may cause an explosion. Turn 

your radio OFF to prevent accidental transmission 

when in a blasting area or in areas posted: "Turn off 

two-way radio." Construction crews often use remote 

control RF devices to set off explosives.

WARNING!

  Read this information before using the 

radio. In August 1996 the Federal Communications 

Commission (FCC) of the United States with its action 

in Report and Order FCC 96-326 adopted an updated 

safety standard for human exposure to radio 

frequency electromagnetic energy emitted by FCC 

regulated transmitters.
Those guidelines are consistent with the safety 

standard previously set by both U.S. and international 

standards bodies. The design of the radio complies 

with the FCC guidelines and these international 

standards.
Never allow children to operate the radio without adult 

supervision and the knowledge of the following 

guidelines. 

FCC RF EXPOSURE

WARNING!  

It is up to the user to properly operate 

this radio transmitter to insure safe operation. Please 

adhere to the following: 
Do not use the radio with a damaged antenna. If a 

damaged antenna comes into contact with the skin, a 

minor burn may result. Please contact your local 

dealer for a replacement antenna.

Hand-Held Operation (Held-to-Face)

This device was evaluated for typical hand-held (held-

to-face) operations with a 1 inch spacing from the 

front of the radio. For hand-held operation, the radio 

should be held 1 inch from the user's face in order to 

comply with FCC RF exposure requirements.

© 2019 Uniden America Corporation 

Issue 3, June 2019

All rights reserved  

Printed in China

LEGAL REMEDIES:  This warranty gives you specific legal 

rights, and you may also have other rights which vary from state 

to state. This warranty is void outside the United States of 

America and Canada. 
PROCEDURE FOR OBTAINING PERFORMANCE OF 

WARRANTY:  If, after following the instructions in the owner’s 

manual you are certain that the Product is defective, pack the 

Product carefully (preferably in its original packaging). The 

Product should include all parts and accessories originally 

packaged with the Product. Include evidence of original 

purchase and a note describing the defect that has caused you 

to return it.The Product should be shipped freight prepaid, by 

traceable means, to warrantor:
Uniden America Corporation 

C/O Saddle Creek 

743 Henrietta Creek Road, Suite 100 

Roanoke, TX  76262

Summary of Contents for GMR3050-2C











Reviews: