Uniden EXP 7900 Series, User Manual

Page: 5 / 12

Installation
Charging the Battery Pack
The rechargeable Nickel-Cadmium battery pack must be fully
charged before using your phone for the first time. Before
plugging the phone line into your new phone, you must
charge the battery for approximately 15-20 hours
without interruption.
1. Remove the handset battery cover.
2. Plug the battery’s
cable into the handset
and place the battery
pack inside the
battery compartment.
3. Replace the battery cover.
▼
Charging the Handset
Place the handset on the
base to charge. (The
handset can charge in
either the face-up or
face-down position.)
▼
Low Battery Indicator
When the battery pack in the handset
is low and needs to be charged, the
batt
LED flashes every 3 seconds.
If this occurs while you are on the
phone, you will hear an alert tone.
Complete your call as quickly as
possible, and return the handset to
the base for charging.
▼
Cleaning the Battery Contacts
To maintain a good
charge, it is important
to clean all battery
contacts on the handset
and base about once a
month. Use a pencil eraser
or other contact cleaner.
Do not use any liquids
or solvents.
Selecting a Location
Before choosing a location for your new phone, read the
“Installation Considerations” included in the “Precautions and
Important Safety Instructions” brochure.
Setting the Dial Mode Switch
5
talk flash
mem
talk batt
Contacts
!
Important: Do not place the power cord in an
area where it may create a trip hazard or
become chafed and create a fire or
electrical hazard.
1
2
3
NOTE
The plastic connectors will fit together only one
way. Make sure the battery’s connector is
properly aligned. Use only the Uniden battery
pack (model BT-905).
Place the switch in the
T
position for tone dialing, or
the
P
position for
pulse dialing.
C:...Exp 7900 series.vp
Fri Oct 30 14:17:54 1998
Color profile: Disabled
Composite Default screen