Uniden exa2850 - EXA 2850 Cordless Phone, Owner'S Manual, Page: 12 / 48

If your telephone outlet isn’t modular,
contact your telephone
company for assistance.
[ 10 ] G E T T I N G S TA R T E D
D D.. CCh ho oo ossee tth hee d diiaalliin ng g m mo od dee
Most phone systems use tone dialing which sends DTMF tones through the phone lines.
However some phone systems still use pulse dialing such as in rural areas. The default
setting is tone dialing. Depending on your dialing system, set the mode as follows:
1) Press and hold ffllaassh
h until you hear a conf irmation tone.
2) To set the dial mode for pulse dialing, press #
# .
Or to set the dial mode for tone dialing, press
*
/tto
on nee.
A conf irmation tone sounds to indicate the setting is complete.
•
If you are not sure of your dialing system, set for tone dialing. Make a trial call.
If the call connects, leave the setting as is, other wise set for pulse dialing.
•
If your phone system requires pulse dialing and you need to send DTMF tones for
cer tain situations during a call, you may "switch-over" to tone dialing.
(Refer to "Tone Dialing Switch-over" on page 15.)
Modular
Make sure your battery
pack is fully charged
before choosing the
dial mode.
5) Connect the telephone line cord to the TTEELL LLIIN NEE
jack and a telephone outlet once the handset is
fully charged.
Af ter installing the batter y pack in the handset, charge your handset at least
1 12 2--1 15 5 h ho ou urrss b beeffo orree p pllu ug gg giin ng g iin ntto o tth hee p ph ho on nee lliin nee. Once the handset batter y pack is
fully charged, connect the telephone line cord to the base and telephone wall outlet.