Uniden DX 834 Series, Instruction Manual, Page: 19 / 28

Dialing a Stored Number
To dial a number previously stored in memory, follow
these steps:
1.
Remove the
Handset from the
Base Unit.
2. Press
T
.
3. Press
M
.
4. Press the memory location number (0-9).
Chain Dialing
On certain occasions, after dialing a number, you
may be requested by the party or service you are
calling to enter a special access code, such as when
performing a banking transaction. To do this, simply:
1. Store the access code into one of the memory
numbers.
2. Dial the main number.
3.
At the appropriate time, press
M
followed by
the memory location number where the access
code is saved.
Problem Suggestion
Charge light won’t come on when Handset is placed in Base
Unit.
•
Make sure AC Adapter is plugged into the Base Unit and
wall outlet.
•
Make sure Handset is properly seated in Base Unit.
•
Make sure that the charging contacts on the Handset and
Base Unit are clean.
Audio sounds weak and/or scratchy.
•
Make sure that the Base Unit antenna is fully extended
and vertical.
•
Move the Handset and/or Base Unit to different locations
and try again.
•
Press the
C
button to select another channel.
Can’t make or receive calls.
•
Check both ends of the Base Unit telephone line cord.
•
Make sure the AC Adapter is plugged into the Base Unit
and wall outlet.
•
Disconnect the AC Adapter for a few minutes, and then
reconnect it.
Handset doesn’t ring or receive a page.
•
Nickel-Cadmium battery pack may be weak. Charge the
battery on the Base Unit for 15–20 hours.
•
Extend the Base Unit antenna vertically.
•
The Handset may be too far away from the Base Unit.
•
Place the Base Unit away from noise sources.
•
The Digital Security Code may be erased. Set the Digital
Code.
DX834/DXC834 19