Uniden DCT5280, Owner'S Manual

Page: 32 / 84

G E T T I N G S TA R T E D [ 30 ]
Setting the Dial Mode
1) Enter the “
Global Setup
” menu, then the “
Dial Mode
” submenu
(see “Entering the Menu” on page 23).
2) Press volume/
▲
or
▼
to change the selection, “ Tone ”
or “ Pulse ” (the initial setting is Tone).
3) Press the OK soft key. You will hear a confirmation tone.
System Reset
De-register the Handset
1) Enter the “ System Reset ” menu, then “ Deregister HS ” submenu
(see “Entering the Menu” on page 23).
2) Press volume/
▲
or
▼
to select the handset ID to be
de-registered from the list, then press the OK soft key.
3) Press the OK soft key. You will hear a confirmation tone.
When de-registration is complete, “
Deregistration
Complete
” appears.
4) After de-registering the handset, move to “Replacing
the Base Setting” below.
Replacing the Base Setting
1) Enter the “ System Reset ” menu, then “ Replacing
Base ” submenu (see “Entering the Menu” on page 23).
“ Do you want to replace Base? ” appears.
2) Press the OK soft key. You will hear a conformation
tone. The base information will be deleted.
D i a l M o d e
T o n e
P u l s e
BACK BACK OK
W h i c h H a n d s e t ?
H a n d s e t # 1
H a n d s e t # 2
BACK BACK OK
A r e y o u s u r e
t o d e r e g i s t e r
H a n d s e t # 1 ?
BACK BACK OK
D o y o u w a n t t o
r e p l a c e B a s e ?
BACK BACK OK
When replacing the base is complete, “
Please Register
” appears, register the
handset(s) to the new base (see page 65).
DCT5280_UP302BH UP01302BA_1 5/23/03 1:55 PM Page 30