Uniden DASH VIEW 50, Owner'S Manual

Page: 8 / 28

8
Vehicle Recorder UNIDEN DASH VIEW 50/50R
Installing the Rear Camera
Install the rear camera at the centre top of the rear windshield.
1. Clean the area before installation.
2. Peel off the sticker protective film from the 3M sticker.
3. Press and apply force on the sticker mount onto the back windshield. The
AV cable outlet needs on the left side in the car facing forward direction.
4. Connect the rear camera to the front camera with the AV cable.
5. Arrange and hide the cables to avoid obstruction for the driver’s view.
6. Adjust the viewing angle of the camera by rotating the body of the camera.
We recommend the camera should point slightly downwards ~10° below
eye level.
Installing the Optional Hardwiring Kit
If you wish to use the parking mode on the camera, you will need to install the
hardwiring kit provided.
1. Locate the location of the fuse box in your vehicle.
2. There are 3 wires that need to be connected: connect the
Yellow cable
that goes to a constant fuse, RED cable that goes to an ignition-switched
fuse and BLACK cable that goes to a metal ground bolt.
YELLOW cable connect to BATTERY (+)
RED cable connect to car ACC
BLACK cable connect to car GROUND
3. Connect the micro USB end of the hardwiring cable to the camera micro
USB port.
4. Start your vehicle to see if it works. Arrange and hide the cables to avoid
obstruction for the driver’s view.
It is advisable to get a car electrician to professionally install the hardwiring
kit.
NOTE
Before installing the HWK-1R, please ensure there is no SD
Card installed on the camera unit. Only install the SD card once
the HWK-1R is finish installing.