INSTALLATION
Location
Plan the location of the transceiver and microphone bracket betöre starting the
installation. Select a location that is convenient for operation and does not interfère
with the driver or passenger in the vehicle. In automobiles, the transceiver is usually
mounted to the dash panel with the microphone bracket beside it.
Mounting and Connection
This radio is supplied with a universal mounting bracket. The transceiver is held in
the bracket by the two thumb screws supplied. permitting adjustment to the most
convenient angle. The bracket must be mounted with the machine screws supplied.
The mounting surface must be mechanically strong. Proceed as follows to mount the
transceiver:
1. After you hâve determined the most convenient location in your vehicle, hold the
radio w ith mounting bracket in the exact location desired. If nothing interfères
w ith mounting it in the desired position, remove the mounting bracket bolts.
Before drilling the holes, make sure nothing w ill interfère with the installation of
the mounting bolts.
2. Connect the antenna cable plug to the standard réceptacle on the rear panel. Most
CB antennas are terminated with a type PL-259 plug which mates with the
réceptacle on the rear panel.
3. Connect the DC power input wire with the fuse (red) to +12V DC. This wire
extends from a plug which connects to the rear panel. In automobile installations,
+ 12V DC is usually obtained from the accessory contact on the ignition switch.
-
6
-
