Care, Maintenance and Repair
SSK 3.1 | Version 1.07
11
All plastic parts and painted surfaces should be cleaned
with a soft, damp cloth and some neutral detergent.
Keep the tool clean and dry.
9.2 Maintenance and repair
If the sandblasting booth does not work properly, contact
a dealer or our customer service. The contact details can
be found in chapter 1.2 Customer Service.
All protective and safety equipment must be reinstalled
immediately after repair and maintenance work has been
completed.
The air hoses should be checked at regular intervals for
damage and leaks. The damaged hoses must be re
-
placed.
Hose material compressed air hose: PVC. Bursting pres
-
sure: 16.5 bar
Clean the tool regularly from dirt. Regular cleaning
makes working with the pneumatic tool easier.
After 10 to 12 hours of operation, check the nozzle. In
the event of uneven wear, the nozzle should be turned 1/
4 turn every 10 operating hours.
In order to ensure a good flow of the blasting medium,
the compressed air must be dry and free of oil. Regularly
check the quality of the compressed air, if necessary
upstream with a drainage system.
In case of uneven flow of abrasive, close the nozzle for a
short time and press the pedal for a few seconds to blow
the system free.
Check the quality of the abrasive regularly. If the particle
size is too small or if soiled, replace the blasting medium.
Regularly check and clean the filter of the extraction sy
-
stem. Replace if necessary. Filter material: nonwoven fa
-
bric.
Fig. 6: Filter of the Sandblasting cabinet SSK 3.1
Check the fittings for a firm and tight fit and retighten if
necessary.
9.3 Troubleshooting
ATTENTION!
Maintenance and repair work may only be carried out
by qualified personnel.
NOTE!
The filter removes particles with particle sizes of less
than 5 µm. It is temperature stable up to 90 ° C.
ATTENTION!
If any of the following errors occur, immediately stop
working with the sandblasting gun. It can cause
serious injury or damage to the tool. All repairs or
replacement work must only be carried out by quali
-
fied and trained personnel. The tool must first be dis
-
connected from the compressed air source.
Disorder
Possible Causes
Remedy
The device is not working
1. Defective pedal
2. No connection to the compressed
air source
1. Replace the Pedal.
2. Establish compressed air connec
-
tion
Bad ray result
1. Worn jet nozzle
2.Compressor power insufficient
3. Workinig pressure to low
1. Replace blast nozzle
2. Use more powerful compressor
3. Increase working
There is not enough or no blasting
sprayed
1. Nozzle clogged
2. Venting on blasting jar blocked
3. Air pipe blocked on the material in
-
take hose
4. To humid air
5. Line leaking
1. Clean or replace nozzle
2. Clean the breath
3. Clean or replace air tube
4. Insert water separator
5. Replace line
Pressure drop on the sandblasting
gun
1. Compressed air line clogged or
with insufficient cross section
2. Compressed air line to long
1. Clean line or replace with larger
line
2. Lay the cable shortern
