Care, maintenance and overhaul
SSK 2.5 | Version 1.08
11
9.1 Care by cleaning
The sandblasting booth should always be kept in a clean
condition.
All plastic parts and painted surfaces should be cleaned
with a soft, damp cloth and some neutral detergent.
Keep the tool clean and dry.
9.2 Maintenance and repair
If the sandblasting booth does not work properly, contact
a dealer or our customer service. The contact details can
be found in chapter 1.2 Customer Service.
All protection and safety equipment must be reinstalled
immediately after completion of repair and maintenance
work.
The air hoses should be checked at regular intervals for
damage and leaks. The damaged hoses must be re
-
placed.
Hose material compressed air hose: PVC.
Bursting pressure:16,5 bar
Clean the tool regularly from dirt. Regular cleaning
makes working with the pneumatic tool easier.
After 10 to 12 hours of operation, check the nozzle. In
case of uneven wear, the nozzle should be rotated by 1/
4 turn every 10 operating hours.
To ensure a good flow of blasting media, the compres
-
sed air must be dry and free of oil.
Regularly check the quality of the compressed air, if
necessary install a drainage system upstream.In case of
uneven flow of blasting medium, briefly close the nozzle
and press the pedal for a few seconds to blow the sy
-
stem free.
Check the quality of the abrasive regularly. If the particle
size is too small or if soiled, replace the abrasive.
Check and clean the filter regularly. Replace if neces
-
sary. Filter material: nonwoven fabric
Fig. 7: Filter of the sandblasting cabin SSK 2.5
Check the fittings for a firm and tight fit and retighten if
necessary.
Use protective gloves!
NOTE!
Never use harsh detergents for cleaning. This can
lead to damage or destruction of the device.
ATTENTION!
Maintenance and repair work may only be carried out
by qualified personnel.
Dust filter specification
Filtered area
2.35 m²
Flow amount
3.8 m³ / Stunde
Filtered precision
< 5 µm
Filtered efficiency
99.8%
temperature stability
< 100 °C
