10
SSK-Series | Version 1.02
Commissioning
8 Commissioning
Step 1: Select a suitable blasting medium and fill in the
sandblasting booth until max. half funnel
height.
Step 2: The workpiece must be free of oil, grease and
moisture. If necessary, clean the workpiece
before placing it in the blast cabinet.
Step 3: Set the desired working pressure at the com-
pressed air supply (compressor). Make sure
that the maximum pressure is not exceeded!
Adjust according to the sensitivity of the mate-
rial set lower working pressure.
Step 4: Connect the sandblast cabin to the com-
pressed air source.
Step 5: Place the workpiece to be machined in the
sandblast booth and switch on the lighting of
the sandblast cabin.
Step 6: Use the integrated protective gloves to hold
the sand blasting gun and the workpiece and
start sandblasting. Hold the sand blasting gun
at an angle of 45 ° to 60 ° to the workpiece,
with the blasting medium being blown away
from the workpiece against the back wall of
the sandblasting cabin. Use the lever to dose
the blasting agent addition
Step 7: After finishing work, disconnect the tool from
the compressed air source and remove the
workpiece.
WARNING!
Danger of life!
There is danger to your life if you do not follow these
rules.
- Never work on the blast cabinet if you are under the
influence of alcohol, drugs or medicines and / or
you are overtired or suffer from concentration-
impairing illnesses..
- The sandblasting cabin may only be operated by
one person. Other persons must keep away from
the work area during operation.
ATTENTION! HEALTH HAZARD
Inhalation of abrasive material and abrasion can
cause lung damage from fumed silica! Possible for-
mation of a silicosis. Information on this
https//de.wikipedia.org/wiki/Silikose
Particularly hazardous is the inhalation of
substances with particle sizes below 5
μ
m!
Never use abrasives with smaller particle sizes than
0,12 mm and make sure the cab is absolutely tight.
Wear respiratory protection.
Use ear protection!
During operation, a noise level of over 85 dB (A)
may occur. From 85 dB (A), ear protection must be
worn!
Use safety goggles!
respiratory protection!
Use safety shoes!
Use protective clothing!
NOTE!
Before using the sand blasting cabin for the first
time, carry out the following points.
- Check all screw connections on the installed
sandblast cabinets and tighten them if necessary.
- Check the sand blasting cabin for leaks.
ATTENTION!
The sandblasting gun must always be directed away
from the operator. Never work with the sandblasting
cabin door open.
ATTENTION!
Never use sand as abrasive.
ATTENTION!
The workpiece must be clean and dry.
NOTE!
The distance of the blasting gun to the object plays an
essential role and should not exceed 20 cm.