Commissioning
SSK 3.1 | Version 1.07
9
7.3 Compressed air conneciton
To operate the sand blasting cabin you need a compres
-
sor with at least 700 Liters/min Filling capacity and a
container size of at least 100 Liters.The generated air
must be cleaned, free of condensate and oil-free.
Adjustable operating pressure: ca. 3,4 - 8,0 bar.
8
Commissioning
.
Fig. 4: Mechanical door closing mechanism
ATTENTION!
Moisture in the compressed air impairs the flow of
abrasive and can cause clogging and clogging of val
-
ves and line!
WARNING!
Danger of life!
There is danger to your life if you do not follow these
rules.
- Never work on the blast cabinet if you are under the
influence of alcohol, drugs or medicines and / or
you are overtired or suffer from concentration-im
-
pairing illnesses..
- The sandblasting cabin may only be operated by
one person. Other persons must keep away from
the work area during operation.
ATTENTION!
HEALTH HAZARDS
There is danger to your life if you do not follow these
rules. Inhaling of blasting material and abrasion may
result in lung damage due to fumed silica! Possible
formation of a silicosis and silicosis. Information on
this
https: // de.wikipedia.org / wiki / silicosis
Particularly dangerous is the inhalation of substances
with particle sizes below 5 microns! Never use abra
-
sives smaller than 0.12 mm and make sure that the
cabin is completely watertight. Wear respiratory pro
-
tection.
Use ear protection!
During operation, a noise level of over
85 dB (A) may occur. From 85 dB (A),
ear protection must be worn!
Use safety goggles!
Use respiratory protection!
Use safety boots!
Use protective clothing!
NOTE!
Before using the sand blasting cabin for the first time,
carry out the following points.
- Check all screw connections on the installed sand
-
blast cabinets and tighten them if necessary.
- Check the sand blasting cabin for leaks.
- Check the function of the door monitoring. When
opening the cabin doors during operation, the sand
-
blasting booth switches off automatically.
ATTENTION!
The sandblasting gun must always be directed away
from the operator. Never work with the sandblasting
cabin door open.
ATTENTION!
Never use sand as abrasive..
ATTENTION!
The workpiece must be clean and dry
NOTE!
The workpiece must be clean and dry
