Unicorn ENDAT-586EL, User Manual

Page: 43 / 58

37
The ENDAT-586EL All -In-One motherboard
5-7. LED Indicators
The system board comes with two LED indicators on the edge of the motherboard
that indicates the network system status. If you experience any problems with t he
adapter, first make sure the appropriate driver is loaded, the proper cable is
connected to the RJ -45 port and the hub complies with the adapter specification,
such as 10Mbps 10Base-T or 100Mbps 100Bast-TX. Finally, recheck the LEDs.
FUDUP (Full Duplex) Indicator
When indicator is ON, it indicates Full -duplex mode: otherwise, it is OFF. The
adapter supports full duplex at 10 or 100Mbps. If the switch-hub supports the
N-way feature and full duplex, the system automatically runs in full duplex mode.
Tx/Rx (Transmit/Receiver) Indicator
This indicator flashes to display that there is network activity – indicating
transmission or reception data from the network.
5-8. The Setup Program
The package includes a diskette containing the setup program. This progr am
allows you to verify the configuration and isolation of faults.
The adapter’s I/O port address and interrupt request levels (IRQ) are set by the
BIOS. Other default settings can be changed for situations as shown below.
Problem (RESET8139.exe) provides the following function:
•
Displays the current configuration of the adapter
•
Performs network diagnostic tests to verify the operation of the adapters
basic functions, and the adapters ability to communicate over the network
with another adapter.
•
Provides set up for new configuration to make a change specify settings:
Remote BOOT ROM, Flow Control and Full-Duplex mode Enable/or
Disable
Full duplex operation is set automatically if the Full-duplex option is set to Disable.