26
13.1.1.2 Installation type
Change the type of automation installed by selecting the Installation Type and choose between:
• lights
• automations
• automations
13.1.1.3 System management
There are 4 commands available for this submenu: ON, OFF, Edit e Remove.
ON: activates the Klever function. If a system doesn’t yet exist, the devices searches for all the modules connected to the
Klever bus and proceeds automatically to initialise them. If a system is already present, however, it activates the existing
one.
OFF: deactivates the Klever function. It will no longer be possible to send commands to the individual outputs of the home
automation system via the Kblue MyTherm app but the lights and automations scenarios will remain active both on the
programmable thermostat and on the app.
Edit
: Updates the existing Klever system. This command should be used following modifi cations of addition or deletion of
modules performed on the Klever bus.
Remove: removes the previously initialised Klever system.
13.1.1.4 System info
This submenu allows you tu view the list of all modules connected to the Klever bus (ETH-S64RB, ETH-S64A, ETH-I42TR)
with reference to their Serial Number and the possibility to activate and/or deactivate the individual outputs of each
module.
To activate a single output select the icon
, to deactivate it select the icon
.
After the changes use the confi rmation button
to exit by saving, otherwise press the button to cancel.
For changes to the name to be attributed to the single light point or to the single automation, refer to the Home Automation
section of the Kblue MyTherm app (chap.16.4.1).
Summary of Contents for KTsmart
Page 1: ...KTsmart INSTRUCTIONS ON INSTALLATION AND USE...
Page 47: ......