10
Operation of the appliance must be verified
with an ignition test in compliance with the
manufacturer installation instructions.
In any case, the functionality of the following
parts must be checked:
- connection to flue gas exhaust system;
- external vents;
- electric and hydraulic connections.
• Before lighting the stove, carefully read the
use and maintenance manual.
• Remove all equipment inserted in the tank
when packaged and make sure it is clear of
any foreign bodies.
• Check that the crucible is well inserted in its
seat.
• Unroll the room temperature probe placed
at the back of the stove, moving it to
approximately 20 cm from any hot parts.
• Close the combustion chamber door. Never
open the door when the pellet stove is
operating.
• Connect the stove to a socket using the
supplied cable.
Stove ignition
• Before lighting the stove, make sure that
the brazier is clear of pellets and clean from
residues of previous combustion. Otherwise
empty and clean it.
• Fill the tank up to 3/4 with good quality pellets,
compliant with that described in the standard
UNI EN 14961-2;
• Press the ignition switch at the back of the
stove; the display will read “OFF”;
Ignition
• Press the key
for 2 seconds. After a few
seconds, the flue gas extractor fan and the
ignition resistance switch on and the text
“FAN ACC” appears; the igniter LED lights
up.
- After about 1 minute, the text “LOAD WOOD”
appears, the stove loads the pellets and
continues lighting the resistance;
- When the proper temperature is reached, the
display will read “FIRE ON”: this means that
the stove has passed to the last ignition phase
at the end of which it will be fully operational;
the igniter LED switches off.
- After a few minutes, the display will read
“ON1-2-3-4-5” according to the set output,
alternated with the room temperature.
- When the set temperature is reached, the
display will read: “ECO”, alternated with the
room temperature.
- The temperature LED switches on when the
set temperature is reached.
Stove extinction
To switch off the stove, press the key
on
the control panel until the display reads “OFF”.
Even after extinction of the stove, the flue gas
extractor fan will continue running for a preset
amount of time to guarantee quick exhaust of
the flue gas from the combustion chamber.
