9
Installation instructions
3
INSTRUCTIONS
FOR THE INSTALLER
3.1 - GENERAL WARNINGS
WARNING!
This boiler has to be destined for the use for
which it has been expressively designed for.
Any other use shall be considered improper
and therefore dangerous.
This boiler is designed to heat water at a tem-
perature inferior to boiling point at an atmo-
spheric pressure
WARNING!
These appliances are exclusively designed
to be installed inside adequate sites.
Therefore these appliances must not be in-
stalled and operated outdoors. An outdoor
installation could cause malfunctioning and
could be dangerous. For external installa-
tions, it is recommended to use appliances
which are specifically designed and predi-
sposed for this purpose.
3.2 - STANDARD CODES FOR INSTALLATION
The FOKOLUS is a boiler designed for wood burning.
It must be installed according to the installation rules in
force in each destination country.
NOTE: The
boiler must be connected to a heating
system compatible to its performance and its
power.
The appliance must be installed by a qualified
and authorised engineer, under his own re-
sponsibility, guarantees the compliance of the
standards according to the latest regulations.
Before installing the boiler the following
points have to be carried out by a competent
engineer:
a) The whole system should be thoroughly flushed in order
to remove any residual dirt or grime which could
compromise correct boiler operation.
b) Check that the chimney/flue pipe has an adequate
draught, does not have any constrictions, and that no other
appliance’s flue outlets have been fitted, unless the
chimney is serving more than one heating appliance,
according to the specific standards and regulations in
force. The connection between the boiler and chimney/flue
outlet can be made only after this verification has been
carried out.