5
General inf
ormation
1.3 - SAFETY WARNINGS
Please strictly adhere to the safety warnings to avoid danger
and damage to people and property.
Addressees
The following instructions are intended exclusively for special-
ised personnel.
- Interventions on the gas system must only be carried out by
qualified installers in accordance with the law and author-
ised by the relevant gas company.
- The interventions to the electrical system must only be car-
ried out by specialised and qualified personnel, according to
the law.
- Commissioning must be done by professionally qualified
personnel.
Standards
In case of intervention, follow:
- the accident-prevention regulations,
- the environmental protection standards,
- the operating safety standards,
- the provisions of the Insurance Institute against accidents at
work
- Directive 2014/68/UE.
Behaviour in case of fuel leaks
Danger
The leaking of fuel can cause explosions
and serious injuries.
- Do not smoke!
- Avoid naked flames and sparks. Never activate lights or
electrical devices.
- Close the shut-off valve on the fuel supply line.
- Open doors and windows.
- Evacuate people from the dangerous area.
- Inform the gas and electricity company from outside the
building.
- Shut-off electric power supply from a safe position (from out-
side the building).
Behaviour in case exhaust gas leaks
Danger
The exhaust gas can cause fatal intoxica-
tion.
- Switch off the system.
- Ventilate the place of installation.
Interventions on the system
- Close the fuel shut-off valve and make sure that it cannot be
opened accidentally.
- Disconnect the system supply voltage (e.g. acting on the
individual switch or on the main switch) and make sure that
voltage is disconnected.
- Make sure that it cannot be switched on again.
Attention
Any electrostatic discharges may damage
the electronic components.
Before carrying out the works, discharge
the electrostatic charge to the ground.
Hot surfaces
Risk of burns caused by contact with hot
surfaces:
- oil pipes,
- front door and smoke chamber,
could become hot.
Comply with the safety standards at work!
Repairs
Attention
It is not allowed to carry out repair work
on parts with technical safety function. Re-
place the faulty parts with original SCHUS-
TER spare parts only.
Additional components, spare parts and parts sub-
ject to wear
Attention
Spare parts and pieces subject to wear that
were not tested with the system can jeop-
ardise its operation. The installation of parts
not approved and unauthorised modifica-
tions may compromise safety and affect the
warranty rights. For the replacement, only
use original SCHUSTER spare parts.
Behaviour in case of fire spreading
Danger
In case of fire, do not put it out using water
but only use powder, CO2 systems, etc..
As for the diathermic oil and its safe use, we
recommend to strictly adhere to the manu-
facturer's provisions specified on the rela-
tive technical data sheet.
