31
3.7 Sleep Setting
Sleep on: Press Function under on state of the unit till the unit enters the Sleep setting interface. Then
setting
press
or
to switch among Sleep1, Sleep 2 and Sleep 3. After that, press Enter/cancel to confirm the setting.
Sleep off: When the Sleep function is activated, press Function to enter the Sleep setting interface. After
that, press Enter/cancel to can
this function.
Sleep setting is shown as Fig.10.
Fig. 10 Sleep Setting
Sleep off is default after power failure and then power recovery, and the sleep functions is unavailable
under the fan mode.
There are three Sleep modes: Sleep 1, Sleep 2 and Sleep 3.
a. Sleep 1
In the Cooling or Dry mode, the temperature will increase by 1°C after the unit runs under Sleep 1 for 1hr
and 1°C after another 1hr. After that, the unit will run at this temperature.
In the Heating mode, the temperature will decrease by 1°C after the unit runs under Sleep 1 for 1hr and
1°C after another 1hr. After that, the unit will run at this temperature.
b. Sleep 2
In the Cooling mode, the temperature may be set between 16°C -23°C , 24°C - 27°C or 28°C - 29°C
or at 30°C , and their Sleep curves are shown in Fig.11 (Note: The curve is only for reference, the actual
temperature is subject to the time point.).
For example: The temperature in the Cooling mode is set at 25°C . Under the mode of Sleep 2, the
temperature will increase by 1°C every 1hr. After it increases by 2°C in total, it will keep at 27°C. 7 hours
later, it will decrease by 1°C , i.e. 26°C. After that, the unit will keep running at 26°C.
®
®
®
®
®
®
User’s Instructions