6
►
Preparing the machine
The machine is delivered in a cardboard box and is screwed onto a wooden pallet.
♦
Unpacking the machine
- Cut the strapping.
- Open the crate and take out the box containing the accessories.
- Unscrew the nuts securing the machine to the pallet.
- Separate the cardboard box from the pallet.
- Remove the machine from the pallet and place it on wooden blocks.
- Remove the transport screws and washers.
♦
Preparing the site and installing the machine
- Position the machine in its definitive location.
- The machine must be installed on a flat surface.
- It is necessary to leave a space of 5 cm at the back. Do not obstruct the air intakes provided on the top of
the machine.
- An earthed electrical socket corresponding to the characteristics of the machine and a water supply are
sufficient.
(The machine must not operate without its feet)
►
Water connection
A water softener is essential above 5° KH
Water inlet:
- Pressure: 1 - 8 bar (0.1 MPa - 0.8 MPa).
- Fitting: 3/8 female gas (male fitting on the machine).
- Tube: internal diameter 8 mm minimum.
- Provide a shut-off tap.
Intervention underneath the machine at the centre:
Screw the water inlet tube onto the fitting in the machine (photo
opposite).
Draining:
- Fitting: Ø18 mm female (at the back of the basin)
- Tube: internal diameter 12 mm minimum.
- Fitting: Ø12 mm female (on the bottom of the machine in the centre)
- Tube: internal diameter 10 mm minimum.
The drain tube is supplied fitted on the machine.
Then connect the other end of the drain tube to a waste water drain by
ensuring that no adverse slope interferes with good outflow.
NOTE: The tube with the smallest diameter must not include a goose
neck.
⌂
INSTALLATION