15
Programming
The programming mode allows adjusting the steam and hot water time together with the SteamAir
level temperature adjustment.
Hot water / steam delay time adjustment:
To adjust the hot water and steam delay time you have to:
- Switch off the machine by cutting the main switch.
- Keep the programming key (2) pressed on, when switching on until orange blink of the led which
confirms that you have entered the programming mode.
- Place a container under the appropriate outlet and press on the key to set (3 or 4).
- When the level in the container is convenient press again on the key.
- Press on the programming key (2) to confirm the new adjustment and come out of the
programming mode (the led blinks twice in orange).
SteamAir temperature adjustment:
To adjust the SteamAir temperature, you need (with power on) to:
- Maintain the key pressed on until orange blink of the led which confirms that you have entered
the programming mode.
- Press the SteamAir key paying attention to the number of blinks and colour of the led which
shows the temperature adjustment registered: the led lights in orange, it means that the adjustment
is as in factory 62°C.
A blink corresponds to a difference of 2°C compared to the factory value; with green colour it is
below, in red it is above.
Examples:
2 green blinks means that the temperature is set to 58°C (62° - 2x 2°)
3 red blinks means that the temperature is set to 68°C (62° + 3x 2°)
To modify the adjustment:
- Each impulse on hot water key (3) reduces the temperature of 2°, on the steam key (4) increases
of 2°.
- Press on the SteamAir key to check the adjustment: check the number of blinks looking the
colour of the led.
- Press on the programming key (2) to confirm the new adjustment and come out of the
programming mode (the led blinks twice in orange)
Note: The temperature adjustment can be done in a range of 50°C to 90°C.
