VLM1/VLM1B User Manual
12
Terminal Block Wire Installation
The following illustrates the Terminal Block Wire Installation procedure for the
VLM1
or the
VLM1B
(not shown):
1.
Be sure wire is stripped to length as shown.
2.
Push desired wire terminal actuator in using 2mm screwdriver provided (as shown)
3.
Slide wire into access hole below the terminal actuator.
4.
Release the terminal actuator.
5.
Wire should be connected – a slight pull on the wire (with the wire remaining stable and
connected) should indicate the wire is properly connected.
6.
Connect the remainder of the wires as required.
7.
For shutter operation, RED wire from actuator coil must connect to Terminal #1 and BROWN
wire from actuator coil must connect to Terminal #2.
Figure 4: VLM1/VLM1B SHUTTER Wire Installation Diagram
Summary of Contents for N-CAS VINCENT ASSOCIATES VLM1
Page 13: ...VLM1 VLM1B User Manual 13 Figure 5 VLM1 to FS Series Shutter Interconnection Diagram ...
Page 16: ...VLM1 VLM1B User Manual 16 Figure 6 VLM1 Dimensional Layout ...
Page 17: ...VLM1 VLM1B User Manual 17 Figure 7 VLM1B Dimensional Layout Fuse Jumper Locations ...
Page 22: ...VLM1 VLM1B User Manual 22 Figure 8 VLM1 VLM1B Schematic Diagram ...
