UTG1000A Series Function Generator User Manual
20
3.3.7
Ramp Wave Setting
Default symmetry degree of ramp wave is 100%. Steps for setting triangular wave with 10kHz
frequency, 2V amplitude, 0V DC offset and 50% duty cycle are seen as following:
Press Menu→Waveform→Type→RampWave→Parameter in turn to enter parameter setting mode.
Select parameter to enter edit mode, then input required numbers and select unit. Note: When enter
symmetry degree value, there is a 50% label at the bottom of display, press corresponding softkey or
use number keyboard.
Note: This parameter can be set by multifunctional knob and direction buttons.
3.3.8
Noise Wave Setting
Default Quasi Gauss noise amplitude is 100mVpp and DC offset is 0mV. Steps for setting Quasi Gauss
noise with 300mVpp amplitude and 1V DC offset are shown as following:
Press Menu→Waveform→Type→Noise→Parameter in turn to enter parameter editing mode. After
setting, enter required number and unit.
