MANUAL - UG2000 SERIES SPRAY GUN CLEANERS
REVISED 2019-03
Prevent Solvent From Entering the Air Passage of Spray Gun:
insert the plastic plug into the air fi tting of the spray gun
as in the photo below. Positive air will fl ow through the
passage way to the cap during cleaning. If the air passage
way has a a male fi tting attach the knurled female nut to
prevent sovlent from entering the air passage way.
This fi tting is located on the chain with the
trigger clamp.
• Close the lid of the spray tank
and turn the "Auto Wash Timer"
clockwise as in photo below
to initiate cleaning. The wash
cycle takes about 60 seconds.
REPLACING SOLVENT:
•
Replace the solvent when the solvent has lost its cleaning
eff ectiveness or after approximately 100 cleanings.
• Close the drain valve (horizontal position).
• Remove the pail of used solvent and install a pail of new solvent.
Dispose of the used solvent in a manner compliant with the laws in
the municipality.
Return the suction hose and drain hose to the pail.
MAINTENANCE:
• Clean the tank of the gun cleaner daily.
Plastic Plug insterted into the air pas-
sage way of the spray gun
Drain Valve in
Closed Position
