Installation Guide
2
Unitronics
Environmental Considerations
Ventilation: 10mm (0.4”) of space is required between the device top/bottom edges
and the enclosure’s walls.
Do not install in areas with: excessive or conductive dust, corrosive or flammable
gas, moisture or rain, excessive heat, regular impact shocks or excessive vibration,
in accordance with the standards and limitations given in the product’s technical
specification sheet.
Do not place in water or let water leak onto the unit.
Do not allow debris to fall inside the unit during installation.
Install at maximum distance from high-voltage cables and power equipment.
Kit Contents
1 UAC-01EC2 module
Diagram
1 Snap-on clips
Physically hold the module in place.
2 USB Host port
Maintenance port: update module’s firmware via USB flash
drive
3 IO/COM Bus-Left
Left-side Connector
4 Bus Connector Lock
Slide the Bus Connector Lock to the left, to electrically connect
the module to the CPU.
5 IO/COM Bus-Right
Right-Side Connector, shipped covered.
Leave covered when not in use.
Bus Connector Cover
6 Functional Ground
Terminal
Connect to the system earth
7 Ethernet port
Supports EtherCAT fieldbus protocol
8 EtherCAT LEDs
Green LEDs
9 Status LED
Tricolor LED, Green/Red/Orange
N
OTE
Refer to the module's specification sheet for LED indications.
10 Module door
Shipped covered with protective tape to prevent the door from
being scratched. Remove tape during installation.
