www.ungerglobal.com
21
HydroPower® RO XXL
Malfunction table
7. MALFUNCTION TABLE
At a possible malfunction one can consult the table mentioned below and if you obtain on this basis no solution, we advise to
contact a DiBO- technician and/or a recognized DiBO- representative.
7.1. Malfunctioning table
Malfunction
Cause
Solution
Machine does not start
Battery insufficient
Recharge and/or replace battery
Control box switched off
Switch on the control box
Rest malfunctions
Consult an expert
Carbon filter blocked
Replace filter cartridge
Instable and to weak pressure
Air in water supply (leaks in water
supply)
Put power off!
Repair leaks in supply.
Spray equipment blocked.
Clean or replace
RO- input valve defective at filling
Consult an expert
Closing mechanism fault of cap
Key contact and/or closing
mechanism defective
Push the locking pin to open and replace
if necessary
Insufficient braking of trailer
Excessive friction losses or
corrosion on the drawbar
Damage caused by impact during
manoeuvring
Remove dirt/corrosion from transmission
remove brake and then check
that the system operates smoothly
Consult an expert
Overheating of the brakes of trailer
Hand brake not released
Jockey wheel blocking linkage
Release hand brake
Release jockey wheel and move into the
correct position
Jerky motion or braking/trailer brakes
when towing vehicle stops accelerating/
overrun device makes noise.
Shock absorber defective.
Replace shock absorber.
Trailer brakes during reverse travel.
Corrosion and/or lack of wheel brake
lubrication.
Remove any dirt and cor lubricate
again.
Arrange for worn brake shoes to be
replaced.
Hand brake too weak to stop trailer mov-
ing backwards.
Too much air in the transmission system.
Brake pads worn.
Braking system adjusted by an expert.
Consult an expert.
ENGLISH
