www.ungerglobal.com
H
I
K
J
F
G
13
HydroPower® Ultra
Resin change
1. Insert the new Ultra Resin Packs with circular movements until they are
completely seated in the tank (fig. F).
CHECK:
The green border of the upper resin pack must sit flat on the inner
edge.
2. Stamp the tank on the floor, so that Resin Pack can settle (fig. G)
3. Tap on the green frame to check correct fit.
It must no longer wiggle, otherwise
the cover cannot be closed.
The green ring on upper Ultra Resin Pack seals the system, ensuring optimum
resin performance.
Never use other resin in this system! This leads to have water spillage in the
top cap and resin spillage in the hose!
4. Replace the cover. Press it down slightly and then turn it clockwise 1/8
without pressing the yellow lever. Fix the device with your feet.
• If the cover is difficult to rotate, lubricate the sealing ring with silicone grease.
• If the cover does not close, stamp the unit on the floor again and check that
the resin packs are seated correctly.
5. First connect the upper (fig H) and then the lower hose.
6. Turn “ON“ water supply at tap (fig. I).
7. Hold down yellow lever to remove trapped air from system. (Abb. J).
8. Test the TDS value (fig. K) The value should be at
000
.
