background image

Millimeter Wave Radar

                     ●

Thank you for purchasing our product. This user manual is a reference 
for using our radar product. Please read the following safeguards and 
warnings carefully before using this series product and keep this user 
manual well for future reference.

Electrical Safety

● All installation and operation should conform to local electrical

safety standard.

● The power supply shall conform to the Safety Extra Low Voltage (SELV)

standard, and DC 12 V power supply shall meet requirements of

IEC60950-1. Please note that power supply shall subject to the require

ment specified on radar label.

● Make sure the power electrical safety before operating the device.
● A readily

 accessible dissembling disconnect device shall be incorporated

in the wiring of the building.

● Prevent the power cable from being trampled or pressed, especially the

plug, power socket and the device adaptor.

● We

 assume no liability or responsibility for all the fires or electrical shock

caused by improper handling or installation.

Environment

● Hard ground is the best choice for detection area, such as cement

ground. 

A

s for the ground covered with vegetation, make sure the height

of vegetation is less than 20cm.

● Make sure the detection area is not blocked by any vegetation, trees,

buildings or vehicles etc.

● Make sure there is no electromagnetic interference around the installa-

tion area and in the radar detection area, such as air conditioner external

unit, high-tension transformer and so on.

● Please transport, use and store the device within the range of allowed

humidity and temperature.

● Do not place the device in a damp or dusty environment, extremely hot

or cold temperatures, or the locations with strong electromagnetic rad-

Summary of Contents for SN-SMWR02A










Reviews: