4
PLEASE READ BEFORE INSTALLATION.
●
When installed in accordance with these instructions, rock sliders do not affect the operation of the
vehicles SRS airbags.
●
This product must be installed exactly as per these instructions using only hardware supplied.
●
Take a few moments to read instructions thoroughly before beginning work.
●
In the event of damage to any bar component please contact Uneek 4x4 in regards to
repair/replacement of components.
●
Do not use this product for any vehicle make or model other than that specified on these instructions.
●
Do not remove labels from this product.
●
This product and its fixings must not be modified in any way unless stated in these fitting instructions.
●
The installation of this product is recommended for trained personnel.
●
These instructions are correct at time of publication. Uneek 4x4 cannot be held responsible for the
impact of any changes subsequently made by the vehicle manufacturer.
●
During installation it is the duty of the installer to check correct operation/clearances of all
components.
●
Installation time: 1.5 hour.
●
Vehicle specific notes: A hydraulic jack will be required. Please note that the threads in the captive nut
end plates are 1.5 pitch.
EYE & EAR PROTECTION REQUIRED
DRILLING REQUIRED
TWO PERSON LIFT REQUIRED
TORQUE SETTING
CUTTING OR GRINDING REQUIRED
FASTENER TORQUE SETTINGS:
M6
–
9Nm (4lb ft)
M8
–
22Nm (16lb ft)
M10
–
44Nm (32lb ft)
M12
–
77Nm (57lb ft)
TOOLS REQUIRED:
Basic tool kit: Hydraulic jack, ‘G’ or ‘F’ clamp, drill and 10mm drill bit, sharp Stanley knife.
