Tracker
2
Assembly & Operating Instructions
5
3.
Locate the hose inlet on the backside of the Tracker
2
, see Figure 5-1. Notice the supplied brass hose
quick-connect. Thread the male end of your 1” hose into the threaded female end of the brass quick
connect. Underhill offers a wide variety of UltraMax
TM
1” hoses in both standard and custom lengths.
See the
www.underhill.us
“UltraMax Hose Series” for more information.
Depending on your water source, more hose maybe needed depending on the area to be
irrigated.
1” Hose Inlet w/ Brass Quick Connect
Figure 5-1
4.
Place the Tracker
2
at the end of the area to be irrigated and nearest the water supply. Consider the
radius of the impact sprinkler and delivery pressure to determine the Tracker’s final position particularly
considering prevailing winds.
5.
Layout the hose parallel to the travel direction of the Tracker, see Figure 5-2 below. Now make the
hose connection to your water supply. Verify the hose is free of dirt, debris and sand by flushing the
hose from the water supply prior to connecting into the Tracker.
Tracker Hose Layout
Figure 5-2
6.
Locate the cable drum nut and trip pin on the side of the Tracker, see Figure 6-1. Pulling outward on
the brass locknut and trip pin. Once released, spool out as much pull cable as needed for the area to be
irrigated. Pull the cable slowly so that it doesn’t unravel too quickly.
Zugseil
bis ca. 100m
ca. 1m
Hydrant
Schlauch
Pflock
!
