3. How to use
2) Auto pairing mode
①
press and hold (MFB) button for 2~4 seconds until you hear the indication tone of turning on from the
UBC-100
speaker and release it. And then, the Blue LED light will flash 3 times rapidly.
②
When UBC 100 is turned on for the first time it will automatically try auto reconnection function
②
When UBC-100 is turned on for the first time, it will automatically try auto reconnection function.
If the function, auto reconnection, is failed to activate then
UBC-100
will be in pairing mode as
Blue & Red LED light rapidly flash alternately, which then repeats “1) Pairing Mode” again.
(4) S t th
bil
h
t
h f
ll
il bl Bl t th
®
®
d i
d
(5) Enter the passkey “
0000
” and press “OK” to pair
UBC-100
with your mobile phone.
When pairing is successfully done
UBC 100
will make the short beep sound and then the Blue LED
(4) Set the mobile phone to search for all available Bluetooth
®
®
devices around.
When searching is complete, select “
UBC-100
” from the list of devices shown.
When pairing is successfully done,
UBC-100
will make the short beep sound and then the Blue LED
light will flash once every 10 seconds.
(6) If prompted by the phone to connect, select “Yes” (This will vary between phones).
Once
UBC-100
is registered and paired with a Bluetooth
®
®
mobile phone, it will remain in the paired status unless
being deleted from the mobile phone, turned off, or out of the operation range, 10 meters(33 feet) from the mobile Phone.
Note
Note
RED LED
Toot-toot
&
Power OFF Pairing Mode Power on Tone
Indicate display
Mobile search
Complete
About 5s
BLUE LED
