3
Rear View
Prepare the Scanner
Prepare your scanner for installation through the following simple steps:
!
Unlock the optical assembly
!
Check and reset (if necessary) the scanner’s SCSI address
!
Run the automatic scanner self-test
Unlock the Optical Assembly of the Scanner
Insert a coin in the thumbscrew of the optical assembly lock and turn it firmly
counterclockwise.
Before attempting to transport your scanner, it is important that you lock the optical
assembly in place to avoid any possible damage to the scanner's optical components.
To lock the optical assembly, insert a coin and turn it until points to the lock mark.
Test the Scanner
The scanner automatically performs a simple self-test each time it is turned on. This
self-test checks the status of certain scanner devices.
After unpacking and unlocking, start the scanner self-test by following the steps
below:
SCSI ID Switch
50-pin SCSI Connector
UTA Connector
Power Cord Connector
25-pin SCSI Connector
Optical Assembly Lock
Power Indicator
Option Indicator
Ready Indicator