808 Gilman Avenue Berkeley, CA., 94710 p:925.253.2960 www.ultraviewcorp.com
USING THE SYNTH1000X2 LABVIEW GUI
The Synth1000 Labview GUI has all the functionality commonly required by most users. In profile
mode, the profiles can be individually selected by software, or alternatively externally toggled by an
input TTL signal through the serial interface. The frequency, amplitude, and phase of each profile can
be individually modified to suit user requirements. Toggling the external profile mode enable switch will
change the profiles rapidly based on TTL input. In external profile mode, each individual profile can still
be modified and the changes will happen at the next clock cycle. Sweep mode allows frequencies,
amplitudes, or phases to be swept through at a user defined step rate. Sweep mode must be disabled
to return to profile mode. External ramp control allows TTL input to pause the sweep, or switch the
direction of the sweep. The external clock select in the upper right disables the internal clock and
accepts a 10mhz external clock input on the GC_P SMA connector on the TTL input pod. The debug
switch in the upper left enables rarely needed monitors below the main window.
When working with multiple boards in a system, each time the board is switched a temporary ini file
with all settings is saved/loaded. These settings can be manually copied to the save/load settings ini
file if desired. The manual save and load buttons work for either a single board, or multiple boards.
The labview project file synth1000x2.lvproj can be opened, edited, and recompiled for custom
functionality to suit every application. Additional calls to the DLL can be set up by looking at the
examples in the main event structure, within the main while loop, and then modified appropriately.
v1r06
Page
16
of
27
Copyright © 2008 – 2010 Ultraview Corporation
Summary of Contents for SYNTH1000x2
Page 2: ......
