6
For transducer positioning and installation, please refer to the separate manual enclosed
which will be relevant to the application and type of transducer and mounting bracket
supplied.
TRANSDUCER POSITIONING and INSTALLATION
FINAL CHECKS
1.
Check the power cable connections:
correct polarity and protected by fuse/breaker.
2.
Check the transducer cable:
connected at both the transducer and control unit. Control
unit connections for transducers must be as per recommendation in section above
–
check!
3.
Check the transducer:
tight down
and no further turn can be made….in good contact!
SWITCHING ON
With the installation checked, switch on the power supply to the Ultra
System.
Switch on the
Control unit and the LED status lights will show at the top.
FINAL CHECKS AND SWITCHING ON
Connect the transducers to the control unit output sockets (TR1, TR3, TR2 & TR4) according to
the number of transducers being used as follows:
1 transducer
–
connect to TR1
2 transducers
–
connect to TR1 and TR2
3 transducers
–
connect to TR1, TR2 and TR3
4 transducers
–
connect to TR1, TR2, TR3 and TR4
Please note:
the output sockets are not marked in numerical order.
TRANSDUCER CONNECTION TO CONTROL UNIT
–
IMPORTANT!
