41
3.2
Positioner Setting
Satellite : Select the satellite which you want to search for the
Service.
-
Press the LEFT/RIGHT ARROW button to select the satellite.
-
If you press the OK button, a complete satellite list will be
displayed.
-
Select the wanted satellite name.
-
If the desired satellite name is not listed then select User
Defined.
Tuner : Select tuner that you want to set (
Tuner 1/ Tuner 2
). If you have set ‘
Loop-Through’
in the
menu(
Installation-Dish Setting-Tuner Connection
), this menu(Tuner) will be automatically disabled.
Frequency : Select the satellite frequency you want to use to check for a signal.
Positioner : Select the positioner.
-
None : (No Positioner)
-
Using DiSEqC 1.2 :
Move :
To move the dish, press LEFT/RIGHT button.
Fine Move :
To move the dish in smaller steps, press the
LEFT/RIGHT ARROW button.
Step :
Set to positioner moving steps as 1, 2, 3, 4
Positioner Command :
To use various positioner commands,
press the OK button. Then, available positioner commands
will appear.
-
Using USALS :
Move :
To move the dish, press the LEFT/RIGHT button.
Fine Move :
To move the dish in smaller steps,, press the
LEFT/RIGHT ARROW button.
Step :
Set to positioner moving steps as 1, 2, 3, 4
Dish Longitude :
Enter the longitude position of the
antenna using the NUMERIC buttons.
Dish Latitude :
Enter the latitude using the NUMERIC
buttons.
Go To :
Press the OK button to rotate the dish to the
selected antenna position.
Dish Setting : Press the OK button to move to
Dish Setting
menu directly.
Service Search : Press the OK button to move to
Service Search
menu directly.
3.3
Service Search
You can select the following search mode.
Auto Search Mode :
-
Satellite :
Press the OK button to select the target satellite
to be searched.
-
Tuner :
Select tuner what you want to set (
Tuner 1/ Tuner 2
).
If you set ‘
Loop-Through’
on the menu (
Installation-Dish
Setting-Tuner Connection
), this menu (Tuner) will be
automatically disabled.
-
Search Type :
Select the search type.
-
Network Search :
You can select Off or On. When you select ‘
On
’, you can find more transponders
using the home network. As it refers to NIT during searching, if there is the frequency information of
other transponder, it searches the other transponder besides the transponder that the user inputs.
-
Time Calibration :
You can select ‘Simple’, ‘Full’ and ‘Off’ to get TDT(Time Data Table) from each TP
-
Dish Setting :
Press the OK button to move to Dish Setting menu directly.
-
Positioner Setting :
Press the OK button to move to the Positioner Setting menu directly.
-
Start Search :
Press the OK button to start search.
Summary of Contents for F-9000HD PVR
