Step 7
Pre
Pre
Pre
Pre----flash set
flash set
flash set
flash set----up.
up.
up.
up.
Your camera’s pre-flash may be set from zero pre-flash up to as many as four. To determine your camera’s
setting, first turn on the Strobe. You will note the red LED is defaulted from the factory to the bottom
light (0 positions).
Press the red button 4 times, this will illuminate the top LED and set the strobe to recognize 4 pre-flashes.
In a darkened room take a picture of the Strobe with your camera on forced flash or auto setting. If the
Strobe flash has not fired your camera is set at less than 4 pre-flashes (if uncertain immediately check the
green ready-light - it will remain on if it has not fired), IF THE STROBE HAS FIRED THIS SETTING IS THE
CORRECT ONE FOR YOUR CAMERA – DO NOT CHANGE.
If the Strobe has not fired, re-set the pre-flash to LED #4 by continually pressing the red button until
position #4 is reached.
Repeat the above procedure by dropping one position until the Strobe fires; this will identify the proper
pre-flash setting that matches your camera. DO NOT CHANGE THIS SETTING; THE STROBE WILL NOW
DEFAULT TO THIS SETTING AUTOMATICALLY WHENEVER IT IS TURNED ON.
It is prudent to check this setting before each dive to assure that you haven’t accidentally changed the
setting.
Step 8
Power output
Power output
Power output
Power output adjustment.
adjustment.
adjustment.
adjustment.
You can easily adjust the flash output power at 10%, 25%, 50% or full power at 100% so that you can
adapt to the lighting conditions of the environment and/or input greater creativity. Simply pushing the
green button cycles the power output. The green LED’s correspond to the graphics imprinted below the
lights.
