5
w
w
w
.ul
tral
u
x.bg
5
w
w
w
.ul
tral
u
x.bg
Code clearing operation: that the original code value of the receiver will be cleared and returned to the
factory state. Then it can be controlled by any compatible remote control, also can be paired to a new
code.
•
Clearing RF Code from drivers/dimmers
Step
Operation
Instructions
1
Connecting the load to
the receiver and power
on it.
1. The clearing operation should be finished within 1 minute after the
receiver is powered on.
2. Batch operation can be performed within the remote control range.
2
Press and hol
d “D” on
the remote control for
5 seconds
1. The indicator of the remote control will flash quickly, see the load
light flashes 3 times and return to the initial state, means pairing
coding is finished successfully
2. If the original remote control is lost, the new remote control can be
used for clearing operations.
3
Press any key to exit
and end the operation
Also will automatically exit code transmission status after 60 seconds
Code learning operation between remote controls: Used to unify system code values or copy a new
remote control.
Since each remote control has its own unique RF code at the time of delivery, when there are multiple
remote controls in one system, one of them must be selected as a main, and other remote controls should
copy its RF code.
1.
Main
remote control: Press and hold
“C”
key for 5 seconds. The indicator of the remote control will
flash quickly, means it enters the pairing code transmission status.
2.
New
remote control: Press and hold
“B”
key for 5 seconds, indicator will turn from 100% to off means it
enters learning code status.
3. Indicator of the new remote control flash three times after successful code learning.
Remote control RF code learning from controllers
1. Turn off the power supply of the controllers.
2. Press and hold
“
B
”
key for 5 seconds until indicator of remote control turns off.
3. Turn on the power supply of the controllers. Indicator of the remote control flashes three times after
successful code learning.
Note:
The distance from controllers to remote controls should be less than 2 meters.
Restoring factory settings of remote control
1. Press and hold “
B”
key for 20 seconds until indicator of remote control process the state as 100% -off-
100%.
2. Press
“D”
button to submit and finish the operation. Indicator of the remote control will flash three
times after successful operation.
RANGE
Range of control on 2.4G Smart system is not limited from the range of remote controller. In a large
premises, exceeding the range of remote controller, drivers/dimers transmits signal among themselves
and inspect the light state for each other. This is possible when distance between drivers/dimers is less
than 10 meters
