Ultrak KEGS5000, User Manual, Page: 13 / 41

2.1 LOCATION OF CONTROLS, CONTINUED
ID Icon Usage Description
15 Multiplexer
Used to place the controller into the multiplexer control
mode.
•
•
•
Press this key once to allow a single command to be
sent to the multiplexer before reverting back to the
SPOT monitor. (LED will flash.)
Press this key twice to lock the controller in the
multiplexer mode. (LED will remain lit.)
To go back to SPOT monitor, press the key again.
(LED will not be lit.)
16
VCR
Used to place the controller into the VCR control mode.
•
•
•
Press this key once to allow a single command to be
sent to the VCR before reverting back to the SPOT
monitor. (LED will flash.)
Press this key twice to lock the controller in the VCR
control mode. (LED will remain lit.)
To go back to SPOT monitor, press the key again.
(LED will not be lit.)
17
PTZ/Dome Call
Used to select the associated PTZ and PreShot for the
current camera.
18
View
Used to recall a preprogrammed view or PreShot on the
current dome or PTZ.
19 Alternate
•
•
•
Used as a shift key.
Holding this down and then pressing the view key will
save a PreShot.
In the Diamond Setup Menus, the alternate key is
used to move the text around the screen. Hold the
key down, then move the joystick to move the text.
20 Auxiliary
•
Used to toggle the backlight compensation of the
KD6 dome ON or OFF.
•
In the KD6 Setup menus, used to enter text.
21 LCD Display
2 lines with 16 characters each give operator feedback
and (in conjunction with the Soft Keys (22)) provide
dynamic menus. See Section 2.4.
22 Soft Keys
Used in conjunction with the LCD display to provide
dynamic menus. Additional commands for each device
are accessible through these soft keys. See Section 2.4.
519222-1960 4 KEMU000499
Rev. C 08/23/02