9
3.2
BASIC
INSTALLATION,
continued
7.
Route the video cable from the monitor location to
the camera location.
WARNING:
Care should be taken when
routing the cable from the monitor to the
camera. Try not to put unnecessary strain
on the cable or connectors. Do not place
the cable next to fluorescent lights as
interference may result. Do not use
staples to support the cable as they may
damage the cable. If the provided camera
cable is not long enough, do not
substitute a telephone cable as it could
damage the camera and/or the monitor.
Contact your authorized Ultrak dealer/
distributor to purchase longer cables.
8.
Plug the cable into the BNC output connector port
labeled VIDEO OUT located on the back of the
camera.
9.
Plug the other end of the cable into the
corresponding video input port on the back of the
observation monitor.
10.
Connect a two-conductor power cable to the 24V ac
or 12V dc input port located on the back of the
camera.
Use a UL-listed Class 2
power transformer and a
24V ac or 12V dc power
adapter. When using a
12V dc power adapter,
connect the positive (+)
pole to the positive (+)
position, and the negative
(-) pole to the negative (-)
position. Use only a Class
2 power source.
continued on next page
12V dc/24V ac Class 2
G
~
~
