ULTRAFRYER Systems F-P25-14, Operation Instructions Manual

Page: 29 / 42

PN 30A169 rev Jan2008 29
NOTE: The following applies only to those fryers that are equipped with a hard dock filtration assembly from Ultrafryer Systems.
A. FILTER TUB ASSEMBLY - ENSURE all components of the filter tub have been thoroughly cleaned and that the Filter Screen has
been assembled; then assemble the filter tub as follows:
1. Connect the KNURLED KNOB to the STANDPIPE DOCKING
HANDLE ASSEMBLY; then attach this assembly to the SUCTION
FITTING on the Filter Screen.
DO NOT OVERTIGHTEN THIS CONNECTION!!!
2. Place the Filter Screen in the bottom of the Filter Tub with the screen
butted against the rear wall of the tub.
3. Insert the Crumb Catcher Screen in the Filter Tub with the Drain Valve
DOCKING FLANGE and MALE DOCKING PLUG over the leading
edge of the pan.
4. P osition the FILTER TUB COVER on the open end of the Filter Tub
with the SLOT on the cover seated around the Standpipe Docking Handle
Assembly. Then, SECURE the cover to the standpipe assembly by locking the
latch on the cover.
B. FILTER TUB INSTALLATION - Position the ASSEMBLED Filter Tub in front of the FILTER TUB GUIDES beneath the fryer;
then CAREFULLY insert the Filter Tub into the fryer using the standpipe handle assy until the MALE In-Line Plug on the Dock-
ing Handle Assembly seats in the FEMALE Bulkhead Socket adjacent to the Drain Valve Assembly.
�������
������
����� �������
������
�������
����
������ ������
����
������ ���
������ ���
�����
��������� �������
������ ����
�����
������� ����
������� �������
���